TOP > PRODUCTS > UBE VERTICAL MILL > TECHNICAL INFOMATION

TECHNICAL INFOMATION

UBE Mill has several unique technologies especially for Slag Grinding Mill.

Catalog Download

SLAG MILL

CONSTRUCTION OF UBE VERTICAL MILL (SLAG MILL)
CENTER CHUTE
By adopting Center Chute which enable Material feed vertically to table center from top of separator, material on table are distributed ideally and ground with high grinding efficiency. Meanwhile, in case of side chute, after long term operation material sticking occur and interrupt mill operation.
Then adopting center chute mill allows long stable mill operation.
MECHANICAL STOPPER
For avoiding metallic contact between roller tire and table liner UBE mill equips MECHANICAL STOPPER. Furthermore, coil spring is equipped in Mechanical stopper for the purpose of cushion of metallic contact impact. Therefore more stable operation will achieved.

Back to Top

TWO WAY SYSTEM

For making stable grinding bed between roller tire and table liner, UBE Slag Grinding Mill adopts 'Two Way System'.
By adopting 'Two Way System', UBE mill are operated under small vibration and achieve god performance.

GRINDING PRINCIPLE OF UBE VERTICAL MILL (TWO WAY SYSTEM)

Back to Top

Roller Arrangement

UBE can apply not only 4 roller mill but also 6 roller mill due to correspond to big capacity and downsizing of mill.

4 Roller Type Series 6 Roller Type Series
4 Roller Type Series 6 Roller Type Series

Back to Top

APPROXIMATE CAPACITY OF UBE VERTICAL MILL SERIES

UBE provides UBE SLAG MILL which meets your request by combination of proper mill size and roller arrangement.

Back to Top