UB-TS Series
Medium Size Die Casting Machine
(Die clamping force: 530t ~ 1300t)
UB-TS Series/Medium Size Die Casting Machine
A Maximum top shot speed of 12 m/s using a proven meter-out circuit used in UBE's large machine models.
Industry's highest filling forcescontribute to improved thin productquality.
(note)11 m/s for 530t,670t only
High-power, high-speed injection system ①
- Meter-out circuit adopted for Medium Size Die Casting Machine.
- Equipped with electric servo valve “HS-DDV” proven in the large iV series.
- Achieving a top shot speed of 12 m/s
High-power, high-speed injection system ②
- UBE's proprietary electric servo valve "HS-DDV” can improve speed response, followability, and acceleration by instantaneously controlling a large volume of hydraulic fluid.
- Intenisification time : 10 msec.
- One of the highest filling forces in the market, capable of maintaining high injection speeds even for thin-wall castings.
- Short filling time improves casting pressure transfer and reduces external and internal defects in castings.
- Inertia force suppression - approximately 30% less burr generation than conventional models.
Operation screen "CastNavi" designed
for ease finding and operating
Identifiable background color by category.
Friendly and memorable design of screen.
Equipped with shortcut keys for quickly access for the necessary items.
Two screens can display set values and actual measured values.
The machine monitor screen displays the operating status of each unit in the same layout as the actual sensor and valve arrangement, improving visibility while also facilitating troubleshooting through the early identification of abnormal locations and conditions.
Increased casting data memory capacity to 15,000 shots.
Saving on External memory while keeping more data on PC.
“Cast Doctor” supports preventive maintenance
and repair and helps improve productivity.
Consumable parts, which have traditionally been managed and replaced based on operating hours and shot counts (time-based maintenance), are instead managed according to actual equipment operating conditions (condition-based maintenance), enabling more precise and optimized equipment maintenance.
When the cumulative operating cycle count reaches the specified threshold, the system displays a notification message prompting the operator to inspect and replace the relevant consumable component as needed.
- Periodic automated diagnostics are performed according to a preset diagnostic schedule, including:
- ①Injection retraction time measurement
- ②Accumulator charge time, hold time, and nitrogen gas pressure measurement
- ③Pump loading pressure measurement
- ④Pump motor current measurement
- These diagnostic functions support early detection of equipment abnormalities and facilitate preventive maintenance and repair planning.
- (Note) Items ③ and ④ are optional.
UBE Technologies Combined to Achieve
the Industry's Fastest 22.5-Second Cycle Time (Option)
①Increased Hydraulic Pump Capacity
Hydraulic oil discharged from the pump is supplied directly to the actuator without waste, achieving shorter die opening and ejector operation times.
②Enlarged Piping Diameter
Improves cylinder operation efficiency by allowing hydraulic oil to flow and discharge more smoothly, reducing resistance.
③Core Run-Around Circuit
Supplies hydraulic oil excess of the pump discharge capacity, to the core cylinder, achieving energy savings and shorter cycle times.
④Intermediate Stop During die Opening
UBE's proprietary control technology enables an intermediate stop of the mold-opening operation even in hydraulic toggle clamping systems. By allowing simultaneous spray operation of both fixed and movable platens, cycle time is further reduced.
⑤Servo Motor Drive for Ladling Device
Precision controls of the ladle angle and arm speed during sleeve pouring , enabling the fastest operation without metal splash.
